Overview
PROJECT AIM:
This project aims to fabricate an electrolysis process system powered by a solar electricity cell to produce green hydrogen.
The water electrolysis process using renewable power is the most well-established technique for manufacturing green hydrogen has been proven in two methods the Polymer electrolyte membrane electrolysis PEM and Alkaline Water Electrolysis. Each method has advantages and limitations.
This project will focus on the Alkaline Water Electrolysis method of the process using the renewable energy of the solar power and will check the efficiency of the solar cell required to power the electrolysis process system and calculate all the requirements measured starting from solar power needed, sunlight period and solar radiation level, solar panel and battery output efficiency, solar panel size, solar panels weigh, water volume, type of water ( amount of hydrogen and oxygen will generate form the prosses. Then will simulate the result values in a small-scale model to prove the concept and calculate the design parameters for industrial application.
PROJECT focused area:
To fabricate Alkaline Water Electrolysis process system powered by a solar electricity cell.
To check the efficiency of the solar electricity cell
To calculate the design parameters for industrial application
Solar energy required.
Number of panel and batters.
ALL Multi parameters have to be calculated and tested to anchor the quality of the system.
Water volume and quality needed for the electrolysis process system
- Green hydrogen storge.
The efficiency and amount of electricity cell needed.
- fuel cell, turns chemical energy into electrical current (DC) and than to AC to run the electricity in Medium size commercial building.
The structure of the report need to be in 6 chapters Experimental Setup , Methodology, calculation and parameters Results and Discussions, Conclusions of the Experimental and Recommendations/Future Work
- All formulas and equations need to be clear and simple
All the calculations will be in the area, and all data will be attached.
I will use the wastewater quality attached
- All calculation needs to be the original scall of the attached data
Finally, convert the data to a prototype scale to be built in a small lab with all flow diagrams and calculations. Including all material list required